1. Check whether the oil level of the brushless gear motor Factory meets the requirements before starting. Follow the prompts to open or remove the vent cover to make it ventilate smoothly, and check if the rotation is flexible.

2. The no-load operation should be carried out about half an hour before the load test operation, and it is confirmed that the no-load operation can be loaded and operated without failure. The test operation should always check the operation: no abnormal shock, vibration, no leakage, or oil leakage. The temperature should not exceed 60℃, and the high oil temperature should not exceed 100℃ (while checking the daily work at any time), it can work normally.

3. If there is an abnormal situation in the operation, the inspection should be stopped, and the work can be continued after the problem is found and eliminated. Check the lubrication status from time to time, pay attention to the amount of oil replenishment, and remove and replace damaged lubricating oil on time.

4. If the installation azimuth is changed, the oil mirror, oil plug, and vent cap can generally be removed.

5. Hard tooth surface gear deceleration should be kept clean at all times, and no dust on the outer surface, so as not to affect heat dissipation.

6. Storage: dry and ventilated. Store at room temperature. Anti-rust treatment should be carried out when the storage period exceeds three months. When the machine is placed for about a year, check whether the oil seal is aging and whether the oil is damaged during use.

Megosztás a facebookon